Hear yourself through headphones exclusively or mixed!

Problem: A performer needs to hear him/herself through headphones exclusively or mixed with the output of a mixer, CD player, tape deck, or other stereo line level source. Only the mic signal, however, should be going to the main mixer.

Solution: Connect MyMONITOR between the mic and line source, and the mixer. The Mic and line Monitor levels can then be adjusted for mix and volume through the headphones. Only the mic signal will go to the board. And since MyMONITOR can be AC or battery powered, the unit can be used on a large stage or wherever there is no AC outlet nearby. Dynamic or condenser mics can be used since phantom power would come through the Mic Thru jack from the mixer or other source.

Usage:

1. If you are using the AC power adapter (included), connect the cable to the 12V DC connector and plug the other end into a 120V AC power outlet. Otherwise, a 9V battery (optional) can be installed in the battery compartment.

2. Set the power switch to the ON position – the Power LED will light up.

3. Connect a low impedance dynamic or condenser mic to the Mic In XLR.

4. Connect a stereo source to the 1/4” Monitor In jack. If the source is mono, only one earpiece will work.

5. Using a low-impedance mic cable, connect the Mic Thru XLR to a mic input on the mixer. If the mic is a condenser, make sure the mixer has phantom power or that you insert a phantom power unit between MyMONITOR and the mixer.

6. Connect headphones to one of the Headphones jacks. Another set can be connected to the other jack.

7. Adjust the Mic Level and Monitor Level controls for the desired mix and volume through the headphones.

Specifications:

• Battery ON/OFF switch

• Power LED

• Maximum Input Level: -20dB mic, 40dB Monitor

• Output Impedance: 10 ohms

• Gain: 15dB 1/4”, 50dB XLR

• S/N Ratio: 90dB

• Power: 12V DC (Adapter included) or one 9V battery

• Dimensions: 4.5 x 2.75 x 1.5 inches (112mm x 72mm x 40mm)